Friday, 27 December 2013

Friday, 20 December 2013

Vintage Hi-Fi Setup

Marantz Model 5220

SONY STR-7035 Solid State Stereo Receiver SONY TC204 SD Casette Deck

Pioneer PL-50L


Sansui Power Meter

Marantz Model 1060

NIKKO-Made In Japan

Garrard 301

Tandberg TR2075

1972 Elac Miracord 50H II Turntable -COPYRIGHT 2010.ALL RIGHTS RESERVED.

Saturday, 14 December 2013

Thorens TD-124 Turntable with SME 3009 S2 Tonearm Painting Photoshop

Thorens TD-124 Turntable with SME 3009 S2 Tonearm

Thorens TD-124 Turntable with SME 3009 S2 Tonearm
TD stands for "tourne-disque" which means literally "record turner" in French. The Thorens TD-124 might be one of the most famous 'audiophile' vintage turntables every made, although some might say that title should go to the Garrard 301 grease bearing turntable. Serious music lovers and audiophiles alike were very fond of this transcription turntable and combined it with tone arms from Ortofon and SME, and with cartridges from Shure and Ortofon.
The Thorens TD124 has an iron cast platter weighing 4.3 kg, sometimes a bit more. It is driven by a relatively strong 10 Watt motor.
AC 4pole induction motor, belt/idler wheel drive, 16, 33, 45 and 78 rpm, mechanically switched, pitch, platter weight 4.5 kg (cast iron) or 3.0 kg (zinc alloy), top platter (aluminium) with clutch, manual operation.
- See more at:

Bang & Olufsen Beogram 3400 Turntable

Friday, 13 December 2013


Belle Klipsch

In 1971 PWK released the Belle Klipsch, a re-proportioned speaker with essentially the same acoustic performance as the LaScala. He named it after his first wife, Eva Belle (Hulling) Klipsch.

Kenwood KR 7340 Quadro Receiver 1975

Kenwood KR 7340 Quadro Receiver
A large Kenwood quadro of the Two-Four series from the early seventies. It is in very good technical and optical condition. I like the elegant wooden cheeks on the left and right side.

25 Watt x4, 60 Watt x2
The function label on the solid aluminum front panel is engraved. No writing imprints may be lost. An impressive device from the golden age of hifi 70s. All functions are checked again and runs like the first day. Unfortunately, there is from the Kenwood series in autonomous design not many more from the series today in daily use.

Wednesday, 11 December 2013

Lo-D ht-500-h Turntable


TANNOY Little Red Monitor

Firestone Antique Record Player

Kenwood KR 7340 Quadro Receiver

DENON TU-500 Stereo Tuner

Luxman 5M21 Power Amplifier

Vega -106 Unitra G602 Made In USSR-Poland

Estonia 55 1956

С начала 1956 года завод ''Пунане-РЭТ'' приступил к  выпуску радиоприёмника 1-го
класса ''Эстония'' (Эстония-55) по году разработки. Футляр у приёмника изначально
рассчитан на установку ЭПУ для последующего выпуска радиолы, или установкой
ЭПУ владельцем. С конца 1956 года выпускалась радиола ''Эстония'', а выпуск при
ёмников прекращён.  Приёмников было выпущено примерно 8 тысяч экземпляров.
''Эстония-55'' это  5-диапазонный 12-ламповый супергетеродинный приёмник со вст
роенной поворотной магнитной антенной для работы на ДВ, СВ, встроенным ЧМ ди
полем и 2-х скоростным электропроигрывающим устройством ЭПУ-III, (в первых вы
пусках ЭПУ-II).  Использованы лампы 6Н3П, 6К4П, 6А2П, 6Н2П, 6Х2П, 6Ж3П, 6П1П,
6Е5С, два блока селеновых выпрямителей. Имеется АРУ,  ограничение амплитуды
ПЧ в диапазоне УКВ, регулировка полосы пропускания ПЧ в АМ диапазонах и регу
лировка тембров по НЧ и ВЧ.  Выпускалась радиола в настольном и небольшой се
рией в напольном оформлении. Диапазоны ДВ и СВ стандартные, KB1 36,6..75,9 м,
KB2 24,8...38,44 м и УКВ 4,11...4,55 м. Чувствительность в диапазонах АМ 50 мкВ,
УКВ 10 мкВ. Избирательность в АМ - 46 дб.  При приёме диапазон звуковых частот
50...5000 Гц, в диапазоне УКВ - 40...13000 Гц, при работе ЭПУ - 60...10000 Гц. Мощ
ность, потребляемая от сети 120/140 Вт. Г абариты 600х435х360 мм. Вес - 23/25 кг

Monday, 2 December 2013

EXCLUSIVE model3401-W

The floor type speaker system which kept the basics faithfully on the basis of the ideal "the speaker which forgets an entity of an audio equipment and can be fascinated by the music itself", and maintained the whole balance for the completeness of each unit with slight height on it.

EL-403 which is a 40cm cone type Woofer is adopted as low-pass.
Newly developed cone paper is used for the diaphragm, and low-pass distortion is reduced by the highly efficient low-distortion magnetic circuit by an AlNiCo-Magnet.

ED-915 of a driver unit and horn EH-351S are adopted as a mid-high range.
ED-915 has realized a 22kHz high region play with the large diameter of 48mm in diameter using the ultralight diaphragm made from a beryllium. Moreover, the Mie slit type was adopted as the fading plug, and the super-precision instrument manipulation and the interval have improved the transient. The AlNiCo-Magnet is adopted as a magnet.
EH-351S of a wood sectoral horn -- the 1st phon and the birch of precision aluminum casting -- it is constituted by wooden [ made of plywood / the 2nd phon of ].

ET-703 which is a horn type super tweeter is adopted as a super-high region.
The combination of a high flux density magnetic circuit with a beryllium diaphragm 35mm in diameter and a rare earth magnet has realized a 45kHz high region play.
Moreover, the horn part serves as a diffraction type with a large directivity.

EN-907 is adopted as a network part.
The design which is equal also to a maximum of 300W input is performed, and a tone-quality modification, such as using the metallized film type focused on a tone quality for a Low-noise-izing, the reduction in direct current resistance, and a capacitor, is aimed at in the coil.
Moreover, the panel side is equipped with the termination for multi-amplifier which is easy to use.